Distributors & Wholesalers of Quality Fabrication Equipment

Looking for a specific product?

Tools with special geometry (BM and OM)

SKU Tools with special geometry (BM and OM)
$0.00
In stock
1
Product Details
Wila also offers special tools in its product range. The design of these tools depends on factors like product shape, sheet thickness, the required inside radius, and the selected adaptation system. The bending method (air bending or bottom bending) is another important factor. These tools are available in virtually any design, in any length and with various surface hardenings. The profile section of the tool can be milled, planed or ground, as desired.

The BM and OM tools can be supplied upon request with a New Standard (in this case, head or shoulder-bearing as desired), European Style or American Style tang. All of the tools of the type BM and OM can be supplied in four standard lengths:

A relatively short standard length of 515 mm / 20.27, making this tool very easy to handle; this length is specified as follows: BM or OM-xxx/1.
A length of 550 mm / 21.65 for the standard segmented set, specified as BM or OM-xxx/2.
A length of 200 mm / 7.87 for two additional segments, 100 mm / 3.94 each. This length is specified as BM or OM-xxx/3.
A length of 200 mm / 7.87.This length is specified as BM or OM-xxx/6.
Using these sets, any length can be made in 5 mm / 0.20 increments.

With the New Standard tang, parts with a length of up to 100 mm / 3.94 can be equipped with one Safety-Click per length; parts longer than 100 mm / 3.94 can be equipped with two Safety-Clicks. For safety reasons, Safety-Clicks are used for tools weighting up to 12.5 kg / 28 lbs. If the tool weights more than 12.5 kg / 28 lbs, it is equipped with locking pins and can only be changed horizontally. For weights of more than 25 kg / 56 lbs, the tools are equipped with safety keys.
Save this product for later

Distributors & Wholesalers of Quality Fabrication Equipment

Tol Free: 1-800-853-9210 Fax: (509)-773-6300